Unable to proceed in compiler, but not receiving any errors

[sundaniel]

Hi Quilter community, this is the first time I am using this tool. I pre-placed a few components from the power stage of my converter, set the board outline in Mechanical Layer 1 (Altium), all the components have footprints (had no issues in Altium v23.9), etc.

However, I am unable to proceed past the constraints page, despite providing minimal constraints. I have included screenshots below. Has anyone else faced similar issues? Can someone from Quilter check out the job URL behind the scenes?

[sergiy]

Hi @sundaniel there was a bug we uncovered here recently. Please try again - and if you still have issues please send me a link to this job so I can dive deeper. If you’d like to keep the conversation private you can also ping me on intercom (the chat bubble on the bottom right of the app).